Roller Shutter Door Spares and Replacement Parts in Centurion

Roller shutter door spares in Centurion are almost always needed at short notice, and the difference between a door back in service today and a door out for a fortnight is whether the part is held locally. We stock the parts our own doors use and the common sizes for the makes that keep turning up on Tshwane sites.

Roller shutter door spares we supply in Centurion

• Slats and curtain sections in the common galvanised and aluminium profiles.
• Guides and guide inserts, including deeper sections for impact-prone bays.
• Springs, shafts and barrel components matched to span and door mass.
• Tube and side motors, gearboxes and manual overrides.
• Bottom rails, locks and end locks.
• Safety edges, photocells, control panels and remotes.

Garage door spares

We carry torsion and extension springs, cables, drums, rollers, hinges, brackets and operator parts for sectional and roll-up garage doors, which covers most of the residential work through Eldoraigne, Wierdapark, Rooihuiskraal, Clubview, Lyttelton Manor, Doringkloof and the newer estates.

Bottom rails and seals after flooding

Properties and premises on the low ground near the Hennops replace more bottom rails and seals than anywhere else we work. We hold those in the common profiles because a corroded bottom rail is both the most likely flood casualty and the part that decides whether the door seals at all.

Identifying the right part

Most wrong parts get ordered from a description. Send photographs of the fault, the barrel end, the guide section and any plate on the motor, plus the opening width. From that we can usually identify the part without a site visit, and we would rather ask for one more photo than send you the wrong item.

Parts for older and obsolete doors

Doors on the older industrial stock through Hennopspark and Zwartkop are frequently out of production. We fabricate or adapt where the profile no longer exists, and we say plainly when adapting is a short-term repair rather than a proper fix.

Supply only or supply and fit

We sell parts across the counter to maintenance teams, facilities managers and contractors who do their own work, and we fit them where you would rather the job was warranted end to end. Tension component work is worth having done by someone with the correct tools.

Consumables worth holding on site

Sites that run doors hard tend to keep a small stock of end locks, bottom-rail seals, photocell pairs and a spare remote. It is very little money against the cost of a dock door standing.

Ordering roller shutter door spares in Centurion

Send photos and the opening size. We confirm the part, the price and whether it is in stock or on order before you commit.